51
EN
cod. 3541S180 - Rev. 04 - 09/2019
» Press the buttons to select the DHW temperature, and then “set” to
enter.
» Press the buttons to change the value.
» Press “set” or to return to the previous menu.
Note: If the thermostat receives the data from the boiler, then it displays this value,
otherwise the setting range is 30 – 60°C.
» Press the buttons
to select information, and then "set" to enter.
» When “
” is displayed, it means the data is not available in the boiler
» Press “set”
or to return to the previous menu.
No. information 4
th
digit on the display
1 Set temperature 1
2 Flow probe 2
3 Return probe 3
4 DHW temperature 4
5 Outside temperature 5
6 Power percentage 6
7 DHW draw 7
8 System pressure 8
» Installer parameters
Exit
» Press “set” to return to the main menu.
To Next Page
Loading...
