What does it mean when my Ferroli ECONCEPT TECH 25 C Boiler shows a heating sensor fault?
If your Ferroli Boiler shows a 'Heating sensor fault', it is likely due to a damaged sensor, which means you should replace the sensor.
What does it mean when my Ferroli ECONCEPT TECH 25 C Boiler shows a high fume temperature?
If your Ferroli Boiler is showing a high fume temperature, it indicates that the exchanger probe is detecting an excessive temperature for over 2 minutes. In this case, you should check the exchanger.
How do I troubleshoot a fan fault in my Ferroli ECONCEPT TECH 25 C?
If your Ferroli Boiler fan is faulty, there are several things to investigate. First, check the 3-pin connector wiring to ensure there is a 230V power supply. Next, inspect the 5-pin connector wiring for any interruption in the tachometric signal. Finally, check the fan itself for any signs of damage.
What should I do if the supply voltage to my Ferroli ECONCEPT TECH 25 C is under 170V?
If the supply voltage to your Ferroli Boiler is under 170V, it indicates an issue with the electric mains. You should check the electrical system.
What does a faulty mains frequency error mean on my Ferroli ECONCEPT TECH 25 C Boiler?
Brief overview of the boiler and its features.
Explanation of the boiler's control panel layout and buttons.
Procedure for lighting and switching the boiler on and off.
Instructions for adjusting various boiler settings.
General guidelines and safety precautions for boiler installation.
Requirements and considerations for selecting the boiler installation location.
Details on making the necessary plumbing connections for the system.
Guidelines for water quality and treatment for the heating system.
Procedure and safety requirements for connecting the gas supply.
Instructions for safe and proper electrical connections to the unit.
Information on connecting an optional room thermostat to the boiler.
Information on connecting an optional external temperature probe.
Procedure for accessing the electrical connection terminal block.
Requirements and guidelines for installing fume exhaust and air inlet ducts.
Details and examples for connecting the boiler using coaxial flue pipes.
Details and examples for connecting the boiler using separate flue pipes.
Guidelines for connecting the boiler to collective flue systems.
Instructions for connecting the condensate drain system.
Procedures for adjusting gas supply and operating parameters.
Checks and procedures for initial lighting and post-maintenance start-up.
Guidelines for periodic checks and maintenance of the boiler unit.
Diagnostic codes and procedures for resolving operational faults.
Diagrams and measurements of the boiler unit and connection points.
Identification and overview of the boiler's primary internal components.
Schematic diagram of the boiler's internal plumbing connections.
Detailed specifications and performance data of the boiler unit.
Graphical representations of boiler performance and circulator data.
Electrical schematic showing connections for boiler components and controls.
To Next Page
General