Festo CP-FB6-E - Page 15

Festo CP−FB6−E 0802f English 15
1User instructionsEnglish
The CP fieldbus node 6 is designed exclusively for use as a
slave on the Interbus. The limit values of the technical
specifications must be observed.
Please refer to the manual P. B E CP−FB6−E... for detailed
information.
Warning
S Switch off the power supply before connecting or
disconnecting plugs (otherwise this could lead to
functional damage).
S Use power supplies which guarantee reliable electri
cal isolation of the operating voltage as per IEC/DIN
EN 60204−1. Consider also the general requirements
for PELV circuits in accordance with IEC/DIN EN
60204−1.
S Connect an
earth conductor of sufficient cross−sec
tional area to the terminal marked with the earth
symbol.
S Only operate a node which is completely fitted and
electrically wired.