Festo SDAT-MHS - Set Cylinder Switch Function

SDAT-MHS
Festo – SDAT-MHS – 2017-11f English 17
5.3.2 Set cylinder switch function
OUT
IN
1
Switching travel
hysteresis
1 Teach point
Fig. 11 Cylinder switch function
Requirement: The piston is in the sensing range (red LED off).
1. Change into the set-up mode (è Chapter 5.1).
2. Press the operating key 2 times.
è Green LED flashes (2 times briefly in succession within 2 s).
3. Move the piston to the switching point (teach point 1).
4. Press the operating key 1 time.
è The switching point is established.
è Change into the operating mode.