Festo P.BE−K−SFC−DC−... 0801c English15
1 User instructionsEnglish
The motor controller type SFC−DC−... serves as a position
controller and position servo control for the electric
mini−slide type SLTE and the grippers HGPLE, HGPPE
(de
pends on firmware status, see manual).
The higher−order PLC/IPC is connected via the controller
interface:
Type SFC−DC−...−IO:digital I/O modules
Type SF
C−DC−...−PB: PROFIBUS−DP
Type SFC−DC−...−CO: CANopen
Type SFC−DC−...−DN: DeviceNet
Commissioning and parameterisation use:
the FCT software package and the SFC−DC plugin
via
the RS232 interface or
for type SFC−DC−...−H2−... optionally with the control
panel (display and four operating buttons).
Note
This brief overview is part of the operator package
P.BP−SF C−DC. It serves only as initial information and
does not replace the complete documentation, which
is
contained as a PDF file on the CD ROM supplied (see
table).
S It is essential that you observe the information and
the safety instructions in the c
omplete manual for the
Single Field Controller.
S Please consult your local Festo Service or write to the
following e−mail address if you have any technical
problems: se
rvice_international@fes to.com
To Next Page
Loading...
Need help?
General
