Contents and general instructions
III
Festo P.BE-SPC11-SYS-EN en 0205a
Contents
Intended use V..........................................................
Service VI...............................................................
Target group VI..........................................................
Important user instructions VII..............................................
Product-specific terms and abbreviations IX...................................
Notesontheuseofthismanual X...........................................
1. Summary of components 1-1........................................
1.1 Structure 1-3......................................................
1.2 Method of operation 1-7............................................
1.3 Display and connecting elements on the SPC11 1-9......................
2. Fitting 2-1........................................................
2.1 Fitting the SPC11 2-3...............................................
3. Installation 3-1...................................................
3.1 General instructions on installation 3-3................................
3.2 Notes on installing the pneumatic components 3-4.......................
3.2.1 Pneumatic emergency stop circuit 3-15.................................
3.3 Fitting the electronic components 3-19..................................
3.3.1 Connecting elements on the SPC11 3-20................................
3.3.2 Connecting the power supply and the I/Os 3-21..........................
3.3.3 Connecting the proportional directional control valve and the measuring system
3-26
4. Commissioning 4-1................................................
4.1 General instructions on commissioning 4-3.............................
4.1.1 Basic principles of configuring and operating the SPC11 4-4...............
4.2 Pre-parametrizing without the drive in the office 4-8......................
4.2.1 Modify parameter 4-11...............................................
4.3 Proceed as follows when commissioning 4-14............................
4.3.1 Preparations for the teach procedur e 4-15...............................