Contents and general instructions
V
Festo P.BE-SPC11-SYS-EN en 0205a
Intended use
The SPC11 has been designed for fitting into a machine or an
automation device. In conjunction wi th permitted drives and
measuring systems and a proportional directional control
valvetypeMPYE-5-...,theSPC11enables:
– fast movement into the mechanical end positions and one
or two selectable mid-positions
– manual movement between the end positions.
Depending on the drive used, fixed stops are in some cases
required for protecting the drive. The end positions can be
set with fixed stops. The end position c ushioning, movement
into the intermediate positions and manual movement are
controlled electronically. The SPC11 must only be used as
follows:
–asintended
– in o riginal condition
– without any modifications
– in faultless technical condition
– only in conjunction with permitted drives/measuring
system combinations.
If used in conjunction with additional commercially-available
components, such as sensors and actuators, the specific
maximum values for pressures, temperatures, electrical data,
torques, etc. must be observed. Please observe also national
and local laws and regulations.
To Next Page
Loading...
Need help?
General
