30
KS 60 E
Wear a P2 respiratory mask to protect your
health. In enclosed spaces, ensure that
there is sufficient ventilation and connect
a mobile dust extractor.
– Replace any sawn-off or damaged limit stops.
Damaged limit stops may be ejected when you
work with the saw. Any persons standing in the
vicinity of the saw may be injured.
– Always use original Festool accessories and
consumables. Only accessories tested and
approved by Festool are safe and perfectly
adapted to the machine and application.
Do not look directly at the light. Optical
radiation can damage the eyes.
2.4 Other risks
In spite of compliance with all relevant design
regulations, dangers may still present themselves
when the machine is operated, e.g.:
– Touching rotating parts from the side: Saw blade,
clamping flange, flange screw,
– Touching live parts when the housing is open and
the mains plug is still plugged in,
– Workpiece parts being thrown off,
– Parts of damaged tools being thrown off,
– Noise emissions,
– Dust emissions.
2.5 Aluminium processing
When processing aluminium, the following
measures must be taken for safety reasons
– Install an upstream residual-current circuitbrea-
ker (FIG, PRCD).
– Connect the machine to a suitable dust extractor.
– Regularly remove dust deposits from the motor
housing.
– Use an aluminium saw blade.
Wear eprotective goggles!
2.6 Emission levels
Typically, the noise levels determined in accordance
with EN 62841 are as follows:
Sound pressure level L
PA
= 91 dB(A)
Noise level L
WA
= 100 dB(A)
Measuring uncertainty allowance K = 3 dB
CAUTION
Operating noise
Damage to hearing
XAlways use ear protection.
The specified emission values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise loads
during operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with other
insertion tools or if not maintained adequately. Take
note of idling and downtimes of machine!
3 Intended use
The power tool is a stationary unit designed for
sawing blocks of wood, plastic, aluminium profiles
and similar materials. Do not use it to process
other materials, in particular steel, concrete and
mineral materials.
Only use Festool saw blades that are designed for
use in this power tool.
Only saw blades with the following specifications
may be used:
– Saw blade diameter 216 mm,
– cutting width 2.3 mm (corresponds to the tooth
width),
– location hole 30 mm,
– standard blade thickness 1.6 mm,
– suitable for speeds above 5000 rpm.
Do not use sanding discs, spacers or spindle rings.
Festool saw blades for woodworking comply with
EN 847-1.
The machine is designed and approved for use by
trained persons or specialists only.
Only saw materials for which the relevant
saw blade has been designed.
The user is liable for improper or non-
intended use.
4 Technical data
Sliding compound
mitre saw
KS 60 E
Power 1200 W
Power supply 220-240 V~ 50/60 Hz
No-load speed 1300 – 3500 rpm
Max. speed * 5000 rpm
Max. mitre angle 60° left/right
Max. inclination angle 47/46° left/right
Saw blade dimensions 216 x 2.3 x 30 mm
Weight 17.8 kg
Safety class
/ II
* Max. speed in the event of faulty electronics
To Next Page
Loading...
