38
KS 60 E
XUndo the screws [12-1] on the guard, remove
the chip deflector and clamp.
XAttach the clamp [12-2] to the new chip deflector.
XScrew the chip deflector [12-3], along with the
clamp, onto the guard.
9.2 Replacing the tabletop insert [13]
Always replace worn tabletop inserts. Never use
the machine without tabletop inserts.
XUnscrew the position marking [10-3] for the
bevel.
XUndo the screws [10-1] in the tabletop insert.
XReplace the tabletop insert [10-2] and position
marking [10-3].
XReattach the screws.
XCheck that the position markings
lie on a
line that, at the same time, must run at a right
angle to the stop rulers.
9.3 Cleaning/replacing the spotlight window
(available as an accessory depending on
the model)
The spotlight SL-KS60 lights up the cutting edge
on the workpiece. Dust-intensive work may affect
the power of the light. Proceed as follows to clean
the spotlight [13]:
XMove the machine into the working position.
XPull out the spotlight window [10-4] by hand,
and clean/replace it.
XReinsert the spotlight window.
The spotlight window audibly clicks into place.
10 Accessories
The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet under “www.festool.com”.
In addition to the accessories described, Festool
also provides a comprehensive range of system
accessories that allow you to use your machine
more effectively and in diverse applications, e.g:
• Trimming attachment KA-KS60
• Base frame UG-KAPEX KS60
• Screw-in feet A-SYS-KS60
• Clamping connection for MFT SZ-KS
• Bevel SM-KS60
• Spotlight SL-KS60
10.1 Bevel SM-KS60 (available as an accesso-
ry depending on the model)
The bevel can be used to gauge any angle (e.g.
between two walls). The bevel therefore forms the
angle bisection.
Gauging the interior angle [14A]
XOpen the locking device [14-2].
XSwivel the router [14-1] out in order to gauge
the interior angle.
XClose the locking device.
The dashed mark [14-4] provides the angle
bisection. The angle bisection can be transferred
via the outside edges of the bevel to the position
markings
on the rotary base.
Gauging the exterior angle [14B]
XOpen the locking device [14-2].
XSlide the aluminium profiles [14-3] on the router
forwards.
XSwivel the router [14-1] out so that the aluminium
profiles are at the exterior angle.
XClose the locking device.
XSlide the aluminium profiles for the two routers
back again.
Transferring the angle [15]
XPlace the angle bevel perfectly in place on one
of the stop rulers .- press with your thumb.
XRelease the rotary knob .
XHook in the detent lever .
XSwivel the rotary base , until the outside edge
of the bevel is congruent with the marking .
To do so, the bevel must be positioned so
that it is parallel to the stop of the com-
pound mitre saw. At the same time, apply
pressure to the stop ruler by pressing in
the recessed grip with your thumb.
XClose the rotary knob , remove the angle bevel.
The angle is transferred, the sawing process can
be started.
To Next Page
Loading...
