Mitre angles according
to scale, horizontal/
vertical
Height x width
[mm]
0°/45° left 55 × 305
45°/45° right 35 × 215
45°/45° left 55 × 215
Maximum workpiece dimensions when instal
ling together with the KA-KS 120
The maximum height and width of the work
piece do not change if accessory parts are in
stalled.
Accessory part used Length
KA-KS 120 (one side) Up to 2400 mm
KA-KS 120 (both sides) Up to 4800 mm
Long workpieces
Provide extra support for any workpieces that
protrude over the sawing surface:
►
Adjust the extension table (see section
7.5).
► If the workpiece still protrudes, retract the
extension table and install the KA-KS 120
trimming attachment (see section
8.1 ).
► Use additional clamps to secure the work
piece.
Thin workpieces
During sawing, thin workpieces may wobble or
break.
► During sawing, thin workpieces may wobble
or break.
► Reinforce the workpiece: Clamp it together
with wood offcuts.
Heavy workpieces
► To guarantee the stability of the machine,
even when sawing heavy workpieces, adjust
the support foot so that it is flush with the
base.
8.2 Check that the pendulum guard can
move
The pendulum guard must always be able
to move freely and close independently.
► Pull out the mains plug.
► Take hold of the pendulum guard and, as a
trial run, slide it into the saw unit.
The pendulum guard must be easy to move
and must be almost fully lowered into the
pendulum hood.
Cleaning the area of the saw blade
► Always keep the area around the pendulum
guard clean.
► Clear dust and chippings by blowing out
with compressed air or using a brush.
8.3 Clamping the workpiece
WARNING
Risk of injury
► Observe the following instructions:
– Secure fit – always clamp the workpiece in
position with the workpiece clamp. This re
quires the hold-down clamp [17.2] to be
resting securely on the workpiece. (Note:
Aids may be required depending on the
workpiece contours, e.g. round contours).
Do not process any workpieces that have
not been securely clamped.
– Size – do not process workpieces that are
too small. In the interests of safety, the cut
piece remaining should be at least 30 mm
long. Small workpieces may be pulled
backwards by the saw blade and into the
gap between the saw blade and the stop
ruler.
– Take particular care that workpieces are
not pulled backwards by the saw blade and
into the gap between the saw blade and the
stop ruler. The risk of this happening is es
pecially high with horizontal mitre cuts.
– Reinforce very thin workpieces [24.1] by
sawing through them together with an ad
ditional wooden slat [24.2] to support
them. During sawing, very thin workpieces
may wobble or break.
Proceed as follows to clamp the workpiece
► Place the workpiece on the saw table and
push it against the stop rulers.
► Open the clamping lever [17.1] of the work
piece clamp.
► Twist the work piece clamp until the hold-
down clamp
[17.2] is positioned over the
workpiece.
► Lower the hold-down clamp onto the work
piece.
► Close the clamping lever [17.1].
8.4 Speed control
The speed can be continuously adjusted be
tween 1400 and 3600 rpm using the adjusting
wheel [2.2]. This enables you to optimise the
cutting speed to suit each material.
English
28
To Next Page
Loading...
Need help?
General