Festool KSC 60 EB - Workpiece Dimensions and Support; Supporting Long Workpieces

Correct support – Observe the maximum work
piece dimensions. Always use and secure ex
tensions to the workpiece support. Otherwise,
the workpiece may be subjected to internal
stresses, which may lead to sudden deforma
tions. Observe the information for workpiece di
mensions (see section 10.4).
10A
10-1
10-2
10-3
10-4
10B
Proceed as follows to clamp the workpiece
► Push the saw unit downwards until it reach
es the limit stop.
► Pull the lever for the transport locking de
vice [10-1]
.
► Slowly guide the saw unit upwards.
► Place the workpiece so that it is flush with
the stop ruler [10-3].
► Use the fastening clamp [10-2] to secure
the workpiece in place.
► Check that the workpiece is securely in
place.
10.4 Observe the workpiece dimensions
Maximum workpiece dimensions without
extension using accessory parts
Mitre/bevel
angle, to
scale
Height x width x length
0°/0° 2-6/16" x 12-1/64" x 28-11/32"
(60 x 305 x 720 mm)
45°/0° 2-6/16" x 8-1/2" x 28-11/32"
(60 x 215 x 720 mm)
0°/45° right 3/4" x 12-1/64" x 28-11/32"
(20 x 305 x 720 mm)
0°/45° left 1-9/16" x 12-1/64" x 28-11/32"
(40 x 305 x 720 mm)
45°/45° right 3/4" x 8-1/2" x 28-11/32"
(20 x 215 x 720 mm)
45°/45° left 1-9/16" x 8-1/2" x 28-11/32"
(40 x 215 x 720 mm)
Maximum workpiece dimensions when
installing together with UG-KS60 and KA-KS60
The maximum height and width of the work
piece do not change if accessory parts are in
stalled. The contact surface when installing the
underframe must be the same as the contact
surface when the extension table is extended.
Accessory part used Length
UG-AD-KS60 28-11/32"
(720 mm)
KA-KS60 (one side) (74-1/16"–110-15/64"
(1880–2800 mm)
KA-KS60 (both sides) 132-9/32"–204-23/32"
(3360–5200 mm)
Long workpieces
Provide extra support for any workpieces that
protrude over the sawing surface:
► Provide extra support for any workpieces
that protrude over the sawing surface:
► Adjust the extension table, see section 9.5.
► If the workpiece still protrudes, retract the
extension table and install a KA-KS60 trim
ming attachment, or raise the compound
mitre saw using A-SYS-KS60 screw-in feet
English
21