Festool MFK 700 EQ - Setting the Mortise Depth; Dust Extraction; Working with the Machine

12
the union nut and clamping collet! They form
one unit.
 Insert another clamping collet with union nut
into the spindle.
 Gently turn union nut. Do not tighten union nut
if there is no cutter inserted!
Setting the Mortise Depth
 Slacken locking mechanisms for routing depth
[1-3] + [1-6] .
 Adjust desired routing depth at the routing
depth setting [1-7] .
 Secure locking mechanisms for routing depth
[1-3] + [1-6] .
Dust extraction
At the extractor connector [1-10] , a Festool mobile
dust extractor with an extraction hose diameter of
27 mm can be connected.
Working with the machine
Please observe all mentioned safety infor-
mations and the following rules when work-
ing:
– Always secure the workpiece in such a manner
that it cannot move while being processed.
– Hold the machine with two hands, one on the mo-
tor housing and one on the gear head or addition-
al handle [1-6] to ensure safe guidance.
– Adapt the feed rate to the cutter diameter and
material. Work with a constant feed rate
1
2
3
5-1
5-2
5-3
5
WARNING
Dust hazard
 Dust can be hazardous to health. Always work
with a dust extractor.
 Always read applicable national regulations be-
fore extracting hazardous dust.