EasyManua.ls Logo

Festool TKS 80 EBS - Page 32

Festool TKS 80 EBS
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LED status in standby
The green
LED [2-4] lights
up constantly.
The bench-mounted
circular saw starts up
in approx. 10 sec
onds.
The red
LED [2-5] flash
es slowly.
The green
LED [2-4] lights
up constantly.
The bench-mounted
circular saw is ready
to use and is in stand
by mode.
The red
LED [2-5] is not
lit.
The green
LED [2-4] flash
es rapidly.
Restart protection
When activating by
pass mode, the yel
low SawStop switch
was released too ear
ly.
To rectify the
fault, press the red
STOP button.
(alternating)
The red
LED [2-5] flash
es rapidly.
The green
LED [2-4] lights
up constantly.
Contact with the saw
blade in standby.
Remove the
contact trigger and
wait approx. 5 sec
onds until the fault is
rectified.
The red
LED [2-5] flash
es rapidly.
The green
LED [2-4] is not
lit.
Cartridge locking de
vice fault.
Switch off the
bench-mounted cir
cular saw and check
the cartridge locking
device.
The red
LED [2-5] flash
es slowly.
The green
LED [2-4] flash
es slowly.
Saw blade missing or
too small.
Switch off the
bench-mounted cir
cular saw and insert a
suitable saw blade
(see section 3 ).
The red
LED [2-5] lights
up constantly.
The green
LED [2-4] is not
lit.
Replace the car
tridge.
Switch off the
bench-mounted cir
cular saw. If the fault
is still not rectified,
insert a new car
tridge.
The red
LED [2-5] lights
up constantly.
LED status during operation
The green
LED [2-4] flash
es rapidly.
The saw blade comes
to a stop.
The SawStop
technology is active
and is triggered upon
contact.
The red
LED [2-5] is not
lit.
The green
LED [2-4] flash
es slowly.
Activated bypass
mode.
The red
LED [2-5] is not
lit.
The green
LED [2-4] flash
es slowly.
Contact with the saw
blade while bypass
mode is activated
The fault is rectified if
the saw blade comes
to a stop.
The red
LED [2-5] flash
es rapidly.
LED status in standby or during operation
The green
LED [2-4] is not
lit.
Workpiece too damp.
Switch off the
bench-mounted cir
cular saw and dry the
workpiece or contin
ue sawing in bypass
mode.
The red
LED [2-5] flash
es rapidly.
English
33

Related product manuals