NOTICE
SawStop technology is triggered
► Do not touch the saw blade when it is
coming to a stop. The SawStop technol
ogy is still active and is triggered upon
contact.
The green LED [2-4] lights up constantly.
The red LED [2-5] is not lit.
The TKS 80 EBS is in standby mode.
► Press the green main switch [2-1].
The TKS 80 EBS is non-operational.
7 Transportation
CAUTION
Heavy bench-mounted circular saw
Risk of injury
► The bench-mounted circular saw must be
carried by two people.
► Hold it by the handle areas on the
side [3-3] for transport. Never take hold of
and transport the power tool by the guard.
► Store the accessories included in the scope
of delivery in the accessory holders or the
brackets provided for that purpose
(Fig. 3a, 3b, 3c).
Accessory holder
Spacer wedge with guard [3-1]
Spacer wedge for grooving [3-2]
Cartridge [3-4]
Push stick [3-5]
Preset profile setting rail
(Take note of the adjustment
markings [3-6] for storing the
preset profile setting rail.)
[3-7]
Power cable
Power cable brackets [3-8]
Power cable [3-9]
Tool
Hex key [3-10]
Spanner for the spindle flange [3-11]
Spanner for the spindle nut [3-12]
► Remove accessories not included in the
scope of delivery.
► Fold in the foldaway legs (see section
6.1 ).
The TKS 80 EBS can be transported.
7.1 Transport rollers
The TKS 80 EBS is equipped with transport roll
ers [1-20] for moving it over short distances.
► Hold the TKS 80 EBS by the handle areas on
the side [1-2] and pull it into the required
position.
8 SawStop technology
The SawStop technology can prevent the most
serious cutting injuries.
The core component of the SawStop technology
is a cartridge that drives an aluminium block
into the saw blade with the aid of a spring. The
mechanism is triggered by a capacitative sen
sor when it comes into contact with human skin
or any other conductive materials during opera
tion.
The SawStop technology only works with a pro
tective earth connection and an earthed power
source. Make sure that power is not supplied
via the SYS PowerStation or a transformer, for
example.
Working with the TKS 80 EBS is only possi
ble if the cartridge is inserted.
WARNING
Noise generated when the SawStop technol
ogy is triggered
Risk of accidents
► Use ear protection.
NOTICE
SawStop technology is triggered
► Do not let the saw blade come into contact
with the rip fence or the cross stop.
NOTICE
The SawStop technology is triggered or
the TKS 80 EBS does not start.
► When sawing cutting widths of ≤ 3 mm, use
a support ≥ 19 mm.
8.1 Function monitoring
The SawStop technology continuously moni
tors the regular operation of the saw. The
LED lights show the current operating status.
English
32
To Next Page
Loading...
