EasyManua.ls Logo

Fiat 500e 2024 - In Case of Emergency; Hazard Warning Flashers; Sos and Assist System

Fiat 500e 2024
224 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IN CASE OF EMERGENCY
HAZARD WARNING FLASHERS
The Hazard Warning flasher switch is located on
dashboard below the radio display.
Push the switch to turn on the Hazard Warning flashers.
When the switch is activated, all directional turn signals
will flash on and off to warn oncoming traff
ic of an
emergency. Push the switch a second time to turn off
the Hazard Warning flashers.
Do not use this emergency warning system when the
vehicle is in motion. Use it when your vehicle is disabled
and it is creating a safety hazard for other motorists.
If it is necessary to leave the vehicle to go for service,
the Hazard Warning flashers will continue to operate
with the ignition key removed and the vehicle locked.
NOTE:
With extended use, the Hazard Warning flashers may
w
ear down your battery.
SOS AND ASSIST SYSTEM
Assist And SOS Buttons
1 — SOS Button
2 — ASSIST Button
The overhead console contains an SOS and ASSIST
butt
on.
WARNING!
ALWAYS obey traffic laws and pay attention to the
r
oad. ALWAYS drive saf
ely with your hands on the
steering wheel. You have full responsibility and
(Continued)
WARNING!
assume all risks related to the use of the features
and applications in this vehicle. Only use the features
and applications when it is safe to do so. Failure
to do so may result in an accident involving serious
injury or death.
NOTE:
Your vehicle may be transmitting data as authorized
by the subscriber
ð
page 211.
The SOS and ASSIST buttons will only function if you
are connected to an operable LTE (voice/data) or 4G
(data) network, which comes as a built in function.
Other Uconnect services will only be operable if your
Brand Connect service is active and connected to an
operable LTE (voice/data) or 4G (data) network.
SOS Call
1. Push the SOS Call button on the overhead console.
NOTE:
In case the SOS Call button is pushed in error,
there will be a ten second delay before the SOS
Call system initiates a call to an SOS operator.
To cancel the SOS Call connection, push the SOS
Call button on the overhead console or press
the cancellation button on the Device Screen.
Termination of the SOS Call will turn off the green
LED light on the overhead console.
IN CASE OF EMERGENCY 167
7

Table of Contents

Related product manuals