CONNECT Nav+
205 Nero 603 83 540 Connect DOBLO Livello 4 GB
205
The “Locate” function is used to dis-
play the vehicle position on the map
with associated pictogram fig. 72.
CHANGE DISPLAY –
INFORMATION ON DISPLAY
When selecting the “Change display”
function on the second page of the
navigation menu, displayed information
may be entered.
The available options are fig. 73:
– Map
– Whole route
– GPS info
– Route info
– Highway info.
“Map”
When this option is selected, the dis-
play shows the map with the two fol-
lowing turns displayed on the left-hand
side.
“Whole route”
With this option, that may be se-
lected only after the system has cal-
culated the route, the display shows
the complete route between current
vehicle position and destination.
“GPS info”
When this function is activated, the
display shows the current vehicle po-
sition (longitude, latitude, altitude) as
well as the number of GPS satellites in
reception. The vehicle is graphically
represented by a symbol within the
cardinal points.
“Route info”
With this option, that may be se-
lected only after the system has cal-
culated the route, it is possible to high-
light the list with the current destina-
tions (with a maximum of 8).
fig. 72
F0D1045g
fig. 73
F0D1055g
To Next Page
Loading...
