39
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
ALPHABETICAL
INDEX
DASHBOARD
AND CONTROLS
Back rest angle adjustment
fig. 42
Operate lever A or lever B to adjust the
required backrest portion, take the back-
rest to position and then release.
Adjusting the central
unit from the inside
To move the backrest to the horizontal
position:
❒
operate the lever D-fig. 44 (one per
side)
❒
fully lower the central backrest
❒
release the lever.
The cup holder A-fig. 43 (where provid-
ed) can be used when the central unit is
all down and the head restraint is removed
(as shown in the figure).
To arrange the central unit back in verti-
cal position, operate lever D-fig. 44 again
(one on each side) and realign the unit
with the side backrests and make the safe-
ty clip E.
fig. 42
F0H0049m
fig. 43
F0H0051m
fig. 44
F0H0050m
Make sure that the seats are
correctly secured after mak-
ing the adjustments.
WARNING
After releasing the adjust-
ment lever, always check
that the seat is locked on the runners
by trying to move it back and forth. If
it is not locked, the seat may move
unexpectedly and make you loose
control of the car.
WARNING
Ski compartment fig. 45
Lower the armrest to access the ski com-
partment.
The compartment may be used for trans-
porting long items (e.g. skis). Insert the
item from the boot.
To access the compartment B lower the
central rear backrest A (as shown above)
fig. 45
F0H0249m
To Next Page
Loading...
