62
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
ALPHABETICAL
INDEX
DASHBOARD
AND CONTROLS
The wiper will flick once to indicate that
the sensor has been reactivated.
The rain sensor is able to recognize and
automatically adjust itself in the presence
of the following particular conditions:
❒
dirt on the controlled surface (salt,
dirt, etc.);
❒
difference between day and night.
Deactivation
Move the lever from position B or turn
the ignition key to STOP.
At the next start-up (key at MAR), the
sensor will not be reactivated even if the
stalk is at B. To activate the sensor, move
the stalk to position A or C and then to
position B or turn the sensitivity adjust-
ment knurled ring.
fig. 73
F0H0073m
Streaks of water may cause
unrequired blade moving.
WARNING
The rear window wiper will run in con-
tinuous mode when the windscreen wiper
is running and reverse gear is engaged.
Pull the stalk towards the dashboard (un-
stable position) to operate the rear win-
dow washer.
Hold the stalk pushed for longer than half
a second to operate the rear window
wiper as well.
Smart wash function is activated as for the
windscreen wiper when the stalk is re-
leased.
fig. 74
F0H0075m
REAR WINDOW WIPER/
WASHER fig. 74
The device can only work when the igni-
tion key is at MAR.
Turn ring A from position
å to posi-
tion
'
to open the rear window wiper as
follows:
❒
in flick mode when the windscreen
wiper is not running
❒
in synchornous mode (at half the fre-
quency of the windscreen wiper)
when the windscreen wiper is running.
To Next Page
Loading...
