Fiat Idea - Page 79

78
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
ALPHABETICAL
INDEX
DASHBOARD
AND CONTROLS
Maximum expansion
Proceed as follows to run the expand the
boot:
❒ remove the rear window shelf as
shown above;
❒ make sure that the head rests are all
down;
❒ use the levers D and E-fig. 112 to
fold the rear cushions;
❒ make sure that the seats are all back
using the handles B or C-fig. 111;
❒ use the ribbons F and G-fig. 112 to
fully fold the seats.
IMPORTANT The seats can only be fold-
ed when they are in all back position.
The folded seats are held in this posi-
tion by the side shock absorbers.
Partial expansion
Proceed in the same manner on the re-
quired seat portion (right or left) to par-
tially expand the boot fig. 115.
fig. 111
F0H0048m
fig. 112
F0H0109m
Never pull the ribbons B or
C-fig. 114 with the seats in
load position because this would
make the seats slide vertically and
prevent folding.
WARNING
fig. 113
F0H0110m
IMPORTANT You may need to move the
front seats forward to tip the rear seats
completely.
Reposition the cushions on the
floor
Use the ribbons B-fig. 113 to position the
cushions on the floor.
Release the middle seat belt
if fastened before tipping.
WARNING