FIBARO Swipe User Manual

SWIPE

FIBARO Swipe Specifications

General

Connectivity	Z-Wave
Power Supply	4 x AA batteries
Dimensions	178 x 140 x 29 mm
Weight	248g (without batteries)
Compatibility	Z-Wave and Z-Wave Plus controllers
Operating Temperature	0 - 40°C
Battery Life	Up to 2 years
Communication	Z-Wave
Type	Gesture Control
Z-Wave Frequency	868.4 MHz EU
Range	30 m indoors
Certification	CE

Summary

Device Installation

Detach the Frame

Slide Out the Plate

Engage the Batteries

Insert the Plate

Attach the Frame

Plug in USB Cable

Adding the Device

Step 1: Login and Select Devices

Login to the Home Center controller and select 'Devices' from the main menu.

Step 2: Add or Remove Device

Select the 'Add or remove device' option and click 'Add' to start.

Step 3: Move Hand to Center

Move and hold your hand close to the center of the pad for about 4 seconds.

Step 4: Confirm Menu Entry

A loud sound sequence confirms entering the menu; keep holding your hand.

Step 5: Swipe Up to Confirm

After two short beeps, take your hand away and swipe up to confirm selection.

Step 6: Wait for Addition

Wait for the device to be successfully added to the system.

Gestures Configuration

Step 1: Access Swipe Settings

Step 2: Assign Reaction

Select a gesture and click the plus icon to create a new reaction.

Step 3: Select Device to Control

Choose the specific device you wish to control with the gesture.

Step 4: Complete Setup

Select the desired reaction and complete the setup by clicking 'Save'.

Gesture Sequences Configuration

Access Swipe and Wake Up

Create Sequences and Add Reactions

Device Selection and Saving

Acoustic Signals and Powering Modes

Menu Operation

Entering the Menu

Navigating Menu Positions

Confirming Selection