with 2 beeps. The quantity applied to platform is then displayed,
d. Sampling process is now completed,
e. Add to or remove from the platform, the corresponding quantity will be
displayed automatically.
NOTE: - To count different articles, press [FUNC] and repeat procedures
listed on 6.7 and 6.7.1.
6.8.2 Shift among Quantity, Average Piece Weight and Weight Info
a. Press [UNIT] to shift among quantity, average piece weight and
weight info,
b. Quantity Display format = numeric numbers & PCS (e.g1000 PCS) ,
c. Average piece weight display format = numeric numbers & weight unit
& / (slash) & PCS (e.g. 499.960g/PCS) ,
d. Weight display format (when Piece Count Function is in effect) =
numeric numbers & weight unit & PCS (e.g. 500 kg PCS).
6.8.3 To quit Piece Count Function
Refer to 6.7.2 on how to quit and back to weighing function.
6.9 PERCENTAGE FUNCTION
Follow the below steps to enter Percentage Function: -
a. Refer to 6.3 on how to select the desired weight unit,
b. If a container is used, place it onto the platform and press [TARE],
c. If a reference mass (mass value which is considered as 100%) is
available, apply it on platform. NOTE: - If reference mass is not
available or reference mass value will be entered through numeric
keys, then ignore this step,
d. Press [FUNC] to shift among various functions until Percentage
Function (PErCnt) appears,
e. Press [M+] to enter,
f. Reference mass value can be entered by anyone of the below
methods: -
By applying the reference mass onto the platform during
After quit, the average piece weight stored will be erased.
Percentage Function does not support memory accumulation (M+) function.
To Next Page
Loading...
