SETTING UP THE COPIER TOUCH PANEL 30
LAN Security (802.1x)
The E100 can seek authentication from an 802.1x authentication server (such as a RADIUS
server), often through an intermediate access point (an authenticator). The E100 seeks this
authentication at startup, or when the Ethernet cable is disconnected and reconnected. If the
E100 is successfully authenticated, it is allowed access to the network.
Press 802.1x Setup to access 802.1x Setup options.
Enable 802.1x Authentication
Off, On
Select this option to allow the E100 to seek authentication from an 802.1x authentication
server.
Select EAP Type
PEAP-MSCHAPv2, MD5-Challenge
Choose the type of EAP (Extensible Authentication Protocol).
User name, password
This information is what the E100 uses to request authentication from an 802.1x
authentication server.
Validate Server Certificate
Off, On
Select this option if you chose PEAP-MSCHAPv2 as the EAP type and want the E100 to use
a trusted root certificate when communicating with the authentication server.
If you want the E100 to validate the server certificate, place the certificate in the list of trusted
certificates of the E100. For more information, see Configure Help.
To Next Page
