ADMINISTERING THE FIERY CONTROLLER 52
Starting, shutting down, rebooting, and restarting the E100
This section describes how to start, shut down, reboot, and restart the E100 when necessary.
TO START THE E100
1 If the E100 is connected to the copier, wait for the Machine Tab to appear on the copier touch
panel.
2 Make sure the E100 power switch is set to ON (|). Press the power button once.
3 Wait approximately 1 minute as the E100 completes the startup sequence.
The LED display flashes intermittently and displays 00. It then flashes intermittently and
displays 00 continuously.
TO SHUT DOWN, RESTART, OR REBOOT THE E100 FROM THE COPIER TOUCH PANEL
1 Press the Application button on the copier.
2 On the copier touch panel, press Fiery.
3 Press the Info tab.
4 From the Server tab, press Reboot Server.
5 If prompted, enter your password.
6 Select Reboot System, Restart Server, or Shut Down System.
Wait for the E100 to shut down, reboot, or restart.
To Next Page
