SETUP OPTION REFERENCE 35
Rip While Receive Setup option
• To access Enable RIP While Receive, choose Configure > Server > Jobs > Enable RIP While
Receive.
SLP Setup options
• To access SLP Setup options, choose Configure > Network > Services > SLP.
Print Master Yes, No
Select Yes to print a FreeForm master when created and printed to the
E100. The master is retained on the E100 after printing unless deleted
later. Select No only to process and hold a FreeForm master on the
E100.
Print to PS Error Yes, No Specify whether the E100 should print the available portion of a
print job when it encounters a PostScript error. Select Yes to print
the portion of the job that was processed before the error occurred;
select No to cancel the print job entirely when a PostScript error is
encountered. Leave this option at No unless you encounter printing
problems.
Use engine internal calibration Yes, No Select No if you want to disable the copier calibration and only use the
E100 calibration.
Symbol Set PC_8, Desktop
,
Roman_8...
Choose the PCL symbol set that best matches the needs of users
printing to the E100.
Option Settings
(default is underlined)
Description
Enable RIP While Receive On
, Off When RIP While Receive is enabled, a print job begins processing
and spooling as soon as the E100 is idle. Otherwise the print job
will begin processing only after it has completed spooling.
Option Settings
(default is underlined)
Description
Enable SLP On
, Off Select On to register the E100 SLP services.
Scope default Define an additional Scope to be included with the published SLP
services.
Option Settings
(default is underlined)
Description
To Next Page
