Fiessler AKAS-3PM - Page 53

WARNING: The Check Daily Procedure must be also performed after any maintenance, adjustment,
modification to the pressbrake safety system AKAS
®
or after each change of tools (upper tool or matrix). Checking
ensures that the AKAS
®
-system and the machine’s control system work properly to stop the machine. Failure to
the check properly could result in serious injury to personnel. The Check Daily Procedure is shown below in this safe-
ty instructions and on the front cover of the AKAS
®
-receiver
If you install and / or operate the AKAS® on machines not capable of this performance
you are in violation of national safety standards. Doing so could result in serious injury to
personnel.
You assume all responsibility for the safety of the machine in question if it is not capable
of this performance.
S2
Safety Instructions
WARNING!
Read and understand this section prior to installing and operating
the system AKAS
®
Please observe always
SI
At the beginning of each shift and after each
change of tools and material, the AKAS
®
Pressbrakes Protection must be checked like
described in page 9.:
If
the machine has not stopped, before the
test piece is touched don't continue to work
with this pressbrake. DO NOT ATTEMPT TO
OPERATE THE MACHINE IN THIS CONDITION!
The pressbrake has to be shut down
WARNING: in this situation the pressbrake safety system AKAS
®
don't provide
the full safety for the operator.
FIESSLER
E L E K T R O N I K
Doku Nr. 1379 Stand 27.1.2017 / Aui