Need help?Do you have a question about the Fike CyberCat 10-064 and is the answer not in the manual?
Lists configurable features available via C-Linx software and panel menus, including UL permitted settings.
Details password levels and privileges to restrict unauthorized access to system menus and features.
Explains various methods for assigning addresses to field devices for proper system recognition and configuration.
Provides access to Device, NAC, SLC, Learn, and Voice operation configuration menus.
Allows modification of operational parameters for addressable devices connected to Signaling Line Circuits (SLCs).
Enables basic configuration changes to each device's alarm features via the Alarm Features screen.
Allows programming of the panel’s two on-board notification appliance circuits (NACs).
Sets operational parameters for the two on-board NAC circuits, including state, protocol, and silencing options.
Identifies installed addressable devices, adding them to the panel’s supervision list with addresses and types.
Identifies only new addressable devices connected to a signaling line circuit (SLC) for supervision.
Resets the device supervision list and learns all addressable devices connected to the SLC.
Sets up the CyberCat system for voice operation, including amplifier channel mode and city sequence codes.
Provides access to Time/Date, Silence, Power, Day/Night Sensitivity, and Zone configuration settings.
Changes system power options, including battery and auxiliary power supervision, and AC transformer size.
Provides access to peripheral device parameters, walktest, ground fault detection, and sensitivity change settings.
Accesses configuration parameters for the panel’s 31 possible peripheral devices.
Modifies basic operating parameters of peripheral devices connected to the panel’s RS485 bus.
Displays the Amplifier menu for configuring zones, messages, and speaker circuits.
Assigns panel states to activate the amplifier and specifies audio message IDs to be played.
Provides access to AC Trouble Delay, VESDA, Aux/NAC, Power Cutoff, and Relay configuration settings.
Configures operating parameters for air sampling detectors connected to the panel via HLI module.
Allows the panel to identify new, unprogrammed addressable devices on the SLC and assign addresses.
Provides configuration options for the CyberCat’s network module, enabling participation in networked systems.
Sets a unique panel ID for network identification and configures supervision of other network panels.
Configures the network module's location, wiring style, switch functionality, and custom messages.
Sets IP address configuration parameters for the panel’s Ethernet module, including Source, History, and Supervision IPs.
Configures the fire panel to supervise other fire panels on the same Ethernet network by setting Panel IDs and IP addresses.
General| Zones | 64 |
|---|---|
| Operating Voltage | 24V DC |
| Enclosure Rating | NEMA 1 |
| Operating Temperature | 0°C to 49°C |
| Storage Temperature | -4°F to 140°F (-20°C to 60°C) |
| Humidity | 93% RH, non-condensing |
| Certifications | UL, FM, CSFM |
To Next Page
