Fike Quadnet - Silencing Buzzer and Exiting Access Levels

Quadnet / Duonet Repeater Panel User Guide
10
Resetting the System
Before attempting to reset the system, the cause of the alarm should be established.
1.
Press ’RESET SYSTEM’
The panel buzzer and the fire indication lights should
switch off.
However, if any alarm condition still exists, eg., a
manual call point requires resetting, then the panel
will revert to the fire state until the cause for the
alarm is removed.
Note: if the panel does not reset or a fault condition is displayed, call your maintenance engineer
immediately.
Sounding the Alarms
To sound the alarms at any time after they have been silenced, proceed as follows:
1.
Press ’SOUND ALARMS’
The alarm sounders will activate. The panel buzzer
and the fire indication lights will also switch on.
Silencing the Buzzer
To silence the panel buzzer press the [SILENCE BUZZER] button at access level two as above .
1.
Press ’SILENCE BUZZER’
The panel buzzer will be silenced.
Exiting Access Level 2A (User) or Access Level 2B (Supervisor)
In order to prevent unauthorised access to the system, return to Access Level 1 (Normal). However, if
left untouched the display will time out after a short while and return automatically to Access Level 1
(Normal).
1.
Turn the key OFF if it is turned on.
Or;
Press ‘ESC’ until the system
shows NORM in the top right hand
corner.
The ‘CONTROLS ENABLED’ light will switch off and
the controls are disabled.
NORM is displayed in the top right hand corner.