Fike Quadnet - Troubleshooting Common Issues

Quadnet / Duonet Repeater Panel User Guide
11
Troubleshooting
Problem
Possible Cause
Remedial Action
Unable to silence
alarms
Panel not in Access Level 2A (User)
or Access Level 2B (Supervisor)
Enter Access Level 2A (User) or Access
Level 2B (Supervisor) - see section on
operation.
Unable to reset system
Alarms not silenced
Silence alarms before attempting to reset
the system.
Panel not in Access Level 2 (User)
or Access Level 2B (Supervisor)
Enter Access Level 2 (User) or Access
Level 2B (Supervisor) - see section on
operation.
Alarm condition still present
Remove cause of alarm, eg. reset call point
element with key
Panel buzzer sounding,
FAULT LED lit
Fault or abnormal condition
Note all illuminated LEDs and displayed
messages.
Call engineer.
Panel buzzer sounding,
POWER FAULT LED
flashing, ‘Mains supply
failed’ displayed.
Mains supply failure
Wait until mains supply is restored – if
panel does not revert to normal operation
call engineer.
Panel buzzer sounding,
SYSTEM FAULT LED
lit
Repeater panel fault
Call engineer immediately.
Any other fault or
abnormal behaviour
Various
Note all illuminated LEDs and displayed
messages.
Call engineer.