Quadnet / Duonet Repeater Panel User Guide
3. View Logs 2. Current Faults
The Active Faults Log will display any current faults. These are displayed in text format and
may be scrolled through by pressing the UP and DOWN keys.
3. View Logs 3. Current Disablements
The Active Disablement Log will display any current disablements. These are displayed in text
format and may be scrolled through by pressing the UP and DOWN keys.
3. View Logs 4. Current Tests
The Active Tests Log will display any current test modes. These are displayed in text format
and may be scrolled through by pressing the UP and DOWN keys.
3. View Logs 5. Event Logs
The Event Log stores 1000 local fire / fault events and 1000 network events which may be
displayed in entirety, or displayed by category. These are displayed in text format and may be
scrolled through by pressing the UP and DOWN keys.
4. Disable / Enable 1. Detection Zone
Not applicable.
.
4. Disable / Enable 2. Device
Not applicable.
.
4. Disable / Enable 3. Sounders
Not applicable.
.
4. Disable / Enable 4. Fire Outputs
Not applicable.
.
4. Disable / Enable 5. Fault Outputs
Not applicable.
.
4. Disable / Enable 6. Default to All Enabled
Not applicable.
.
5. Set Time and Date
This allows the time and date to be adjusted. These settings will need to be re-entered after
the complete removal of power, as the system will simply resume from the point that power
was removed.
To Next Page
Loading...
