Filtec FT-100 - Determining Case Inspector Model

Safety Information 1-15
Document 40275-0913
1.8 Determining the Model of Your Case
Inspector
1.8.1 Steps
Before you operate the FT-100/CI or FT-170/CI ensure that you
are familiar with all safety mechanisms. The FT-170/CI uses X-ray
for inspecting cases. The FT-100/CI uses gamma for inspecting
cases.
Complete these steps to o determine the model of your case
inspector.
1. Check the top of the inspection head.
• If it has a red light and a switch labeled X-ray On/Off it
is a FT-170/CI.
• If it has both a red light and a green light it is a
FT-100/CI.
2. Check the safety labels on the unit.
• If the messages discuss X-ray radiation it is a FT-170/CI.
For more information, see Safety Notices and Safety
Labels.
• If the messages discuss gamma radiation it is a
FT-100/CI.