Page 1
OWNER’S MANUAL
Model: LG-3025-QR (5302322)
(25 Gallon Lawn & Garden/ATV Boomless Sprayer)
General Information
Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your lawn
& garden/ATV sprayer. Please read it carefully, as it furnishes
information which will help you achieve years of trouble-free
operation.
Warranty
Products are warranted for one year from date of purchase
against manufacturer or workmanship defects for home owner
usage and 90 days for commercial usage.
For technical assistance, visit our website @
www.fimcoindustries.com or call: TOLL FREE @ 1-800-831-0027
Our Technical Support Representatives will be happy to help you.
To obtain prompt, efficient service, always remember to give the
following information…
x Correct Part Description and/or part number
x Model #/Serial # of your sprayer
Part descriptions and numbers can be obtained from the illustrated
parts list section(s) of this manual.
www.fimcoindustries.com
1000 FIMCO Lane, P.O. Box 1700, North Sioux City, SD 57049
Toll Free Phone: 800-831-0027 : Toll Free Fax: 800-494-0440
[5008430 (04/16)]
Technical Specifications
x 25 Gal. Corrosion-Resistant Polyethylene Tank
x 12 Volt Diaphragm Pump, 3.8 g.p.m.—45 psi
x Deluxe Pistol Grip Handgun
x 15 Ft. Handgun Hose (3/8” I.D.)
x 26 Ft. Vertical throw, 35 Ft. Horizontal Throw
x 30 Foot Spray Coverage w/Boom
x Corrosion-Resistant Nozzles
Caution: When fully filled with water, this sprayer will
weigh 260 lbs.. Consult the owner’s manual for your
vehicle to verify that you are within it’s load carrying
capacity.
Assembly Instructions
x Make sure the contents of the sprayer’s carton match the
items shown on page 2 of the manual.
x Follow the steps on pages 3 & 4 to properly assemble the
sprayer.
x After assembly is complete and before testing your spray-
er, make sure you connect the electrical hook-up to the
end of your pump and clip the clips to a fully charged bat-
tery. The red wire must be connected to the positive (+)
and the black wire should be connected to the negative (-).
x The drain plug assembly should already be attached to the
tank
***IMPORTANT REMINDER***
To Next Page
Need help?
General
