10
FINES – OPERATING INSTRUCTIONS – ENGLISH version
Prover HTB »HTB16,10-M in HTB16,10-D »
During process it is recommended that you open the doors as less as you can, because of the heat loos.
You can watch the rising of the products through big glass doors.
ALWAYS FOLLOW THIS PROCEDURE AT THE END OF THE PROCESS:
Turn o the device with main switch 0/1!!!
Close the water pipe or valve!!!
12.0. REGULAR CLEANING AND MINTAINANCE
EXTERIOR AND INTERIOR OF THE PROVER MUST BE COOLEDOWN TO ROOM
TEMPERATURE (approximately 25 C) BEFORE CLEANING!
PROVER MUST BE DISCONNECTED FROM ELECTRICAL POWER SUPPLY BEFORE
CLEANING!
DO NOT USE AGGRESSIVE CLEANING AGENTS FOR CLEANING OF THE PROVER
CLEANING OF THE INTERIOR OF THE PROVER CAN ONLY BE DONE WITH CERTIFIED AND
ORIGINALLY PACKED CLEANSING AGENTS, WHICH ARE APPROVED FOR USE IN FOOD
INDUSTRY FOR CLEANING THE INTERIOR OF PROVERS AND ON WHICH IS THIS CLEARLY
SPECIFIED OF THE PACKAGING OF THE CLEANSING AGENT
WHEN USING ANY KIND OF CLEANSING AGENTS IS OBLIGATORY TO USE PROTECTIVE
GLOVES
STRICT COMPLIANCE WITH INSTRUCTIONS for USE and SAFE WORK WITH THE
CLEANSING
AGENT IS OBLIGATORY
IT IS FORBIDDEN TO CLEAN THE PROVER WITH RUNNING WATER or JET OF WATER
WHEN CLEANING, IT IS FORBIDDEN TO USE TOOLS, WHICH MAY MECHANICALLY
DAMAGE THE SURFACE
12.1. REGULAR CLEANING OF THE EXTERIOR OF THE PROVER
EXTERIOR OF THE PROVER is cleaned with a moistened damp cloth or with a mild detergent for
decreasing of metal surfaces.
Clean the CONTROL PANEL only with a moistened soft cloth, never use any detergent!
THE EXTERNAL GLASS OF THE DOOR from the outside shall be cleaned on regular intervals with a damp
cloth or mild cleaning agent for glass.
For all outside surfaces of the PROVER is recommended to use cleaning detergent FINES MOROTO
GX500 and GX500 S that is packed in handy packaging with spra yer for easier spraying, and multi-purpose
cleanerMX200.
12.2. REGULAR CLEANING OF THE INTERIOR OF THE PROVER
METAL PARTS OD THE INTERIOR of the device it is nec essary to clean regularly with wet cloth and
cleaning agent for degreasing surfaces that can be used in the food industry.
For cleaning stubborn grease stains on the metal parts inside, use detergent to clean the PROVER cavity,
which may be used in the food industry, this is exactly hold the manufacturer‘s instructions.
To facilitate the cleaning guides are quickly remov able without tools, if necessary, you can easily remove
and clean place behind them;
Clean the DOOR GASKET with a damp cloth at the end of each working day, never clean the gasket of
thedoor with any detergents;
Clean the INTERNAL GLASS OF THE DOOR with a damp cl oth or mild cleaning agent for glass.
For all outside surfaces of the PROVER is recommended to use cleaning detergent FINES MOROTO
GX500 and GX500 S that is packed in handy packaging with spra yer for easier spraying, and multi-purpose
cleanerMX200.
To Next Page
Loading...
Need help?
General