Fines HTB Series - Warranty Conditions; Contact Details

11
FINES – OPERATING INSTRUCTIONS – ENGLISH version
Prover HTB »HTB16,10-M in HTB16,10-D »
13.0. WARRANTY CONDITIONS
WARRANTY for the product is 24 months,
onlyincase,ifthebuyerpriortothepreviousperiodoftherst12months,orders,atitsownexpensea
preventive check up of the product at the authorized FINES service centre and provided that the service
centre,afterexaminingtheproduct,conrmsthathandlingofthePROVERhasbeencarriedoutwithdue
care and diligence, otherwise the WARRANTY is limited to 12 months!
STANDARD WARRANTY CONDITIONS
This warranty includes replacement of original parts found to be defective and installation free of charge by
the authorised FINES agent.
The warranty becomes efective from the date of saleor installation date of the equipment
under the following restrictive conditions:
1. The equipment is purchased under » normal » conditions;
2. Installation is made by an authorised agent;
3. The equipment is maintained and serviced only by an authorised agent!
4. Utilisation of the equipment conforming to the indications of the instructions for use and for the
purpose for which it is made;
5. The equipment is maintained daily as a good father should and with all due care;
6.Maintenancefollowed-upbytheauthorisedagentconformingtothemaintenancespecications
with at least one maintenance a year (maintenance at the user`s cost); If there is no maintenance
follow-up by an authorised servicer, the warranty is limited to 12 months!
7. Exclusive use of FINES original parts;
This warranty doesn`t cover:
1. Replacement of normally wearing parts (bulbs, seals) and door glass damage;
2. Parts found not to be defective by our dealers;
3. Problems resulting from abnormal use of the equipment;
4. Problems resulting from an installation not ins talled by an authorised agent;
5. Parts where problems result from transport damage or incorrect handling;
Repair and/or replacement of defective parts duringthe warranty period does not extend the initial warranty!
EXTENDED SPECIAL WARRANTY CONDITIONS
Extended special warranty conditions include all the terms of » standard warranty » with exception
ofwarranty period, which is extended!
The Extended warranty may include additional conditions if agreed upon in writing with the purchaser.
14.0. CONTACT DETAILS
MANUFACTURER:
FINES d.o.o.
Industrijska 5, 1290 Grosuplje, SLOVENIJA
Tel: +386 1 788 83 40
Fax: +386 1 788 83 42
Internet:www.nes.si
E-mail:info@nes.si