17
TOOLS YOU WILL NEED
1. ADJUST THE REGULATOR
A. Disconnect all electrical power at the main circuit breaker or fuse
box.
B. Shut off the gas supply to the appliance by closing the manual shut-off
valve.
C. Adjust the pressure regulator by doing the
following:
FIGURE A FIGURE
B
For Natural Gas usage the retainer pin will look like this.
(See Figure B)
FIGURE D
Unscrew the cap with a Crescent wrench.
(See Figure A)
Remove the retainer pin.
(See Figure C)
Proceed
to
reverse the retainer pin and place
it
back into the
regu-
lator cap. This
is
how the regulator pin looks for LP gas
usage.
(See Figure
D)
FIGURE E
5) Screw the regulator cap back into the regulator and
re-at-
tach the regulator to the nipple and are
union.
(See Figure
E)
FIGURE C
To Next Page
Loading...