Firepower FP 125 - APPENDIX 1: OPTIONS AND ACCESSORIES; Feed Roll Installation & Consumable Guide

APPENDIX FIREPOWER FP-125, 135, 165
Appendix A-1 Manual 0-5123
APPENDIX 1: OPTIONS AND ACCESSORIES
• Contact your Thermal Arc distributor to order options and accessories. For assistance in locating a Thermal Arc
distributor, contact the Thermadyne office listed in the inside rear cover that is nearest to you.
• Note the model and specification number shown on the equipment nameplate.
For Tweco/Victor Inquiries and Orders:
Call 1-800-318-6819 Consumable Parts Management Group
Replacement Torch Catalog number 1444-0741
Art # A-09026
FEED ROLL INSTALLATION & CONSUMABLE GUIDE
Part No.
Wire Feed Rolls &
MIG Gun Consumables
Description
1444-0427
Wire Feed Roll, Knurle, .023" - .030" /.035"
(0.6-0.8mm/0.9mm), Hard/Cored
1444-0050
Nozzle
1444-0025
Contact Tip, .023" (0.6mm)
1444-0026
Contact Tip, .030" (0.8mm)
1444-0027
Contact Tip, .035" (0.9mm)
1444-0489
Gas Diffuser
1444-0741
MIG Gun, Complete Assembly
.030"
0.8mm
Weld Wires
Part No. Description
1444-0210
1444-0211
1444-0215
1444-0216
1444-0220
1444-0221
ER70S-6 Mild Steel Wire,
.023" (0.6mm), 2 lbs. (0.9kg) Spool
ER70S-6 Mild Steel Wire,
.023" (0.6mm), 11 lbs. (5kg) Spool
ER70S-6 Mild Steel Wire,
.030" (0.8mm), 2 lbs. (0.9kg) Spool
ER70S-6 Mild Steel Wire,
.030" (0.8mm), 11 lbs. (5kg) Spool
ER70S-6 Mild Steel Wire,
.035" (0.9mm), 2 lbs. (0.9kg) Spool
ER70S-6 Mild Steel Wire,
.035" (0.9mm), 11 lbs (5kg) Spool
E71T-GS Flux Cored Wire,
.030" (0.8mm), 2 lbs (0.9kg) Spool
E71T-GS Flux Cored Wire,
.030" (0.8mm), 10 lbs (4.5kg) Spool
E71T-GS Flux Cored Wire,
.035" (0.9mm), 2 lbs (0.9kg) Spool
E71T-GS Flux Cored Wire,
.035" (0.9mm), 10 lbs (4.5kg) Spool
1444-0230
1444-0231
1444-0235
1444-0236
The branding size at the
end of the feedroll refers
to the size nearest to the mark.
Figure A-1: FP-125 Feed Roll and Consumables Chart