– 14 –
Checking For Open Zones
Checking For Open ZonesChecking For Open Zones
Checking For Open Zones
Using the [
Using the [Using the [
Using the [∗
∗∗
∗] Key
] Key] Key
] Key
Before arming your system, all protected doors, windows and other protection zones
must be closed or bypassed, otherwise the keypad will display a "Not Ready" message.
Use the READY key to display all faulted zones, making it easier for you to identify
and secure any open zone.
1. Press [∗] (do not enter code first) to display faulted
zones.
2. Secure or bypass the zones displayed.
3. The keypad’s READY indicator lights when all
protection zones have been either closed or bypassed.
4. Arm the system as desired.
Alpha Display:
DISARMED
HIT ∗ FOR FAULTS
Fixed-Word Display:
Zone no. and “NOT READY”
Voice Status: Voice Keypads (if installed), can announce system status and faulted
zones (up to 3 zone descriptors) if the Voice Status feature is turned on.
To turn the Voice Status feature on/off:
# + 0 + 2 + 4
(also turns on Voice Chime mode; see Chime mode section)
To announce Status: Press [#] FUNCTION + [0] VOICE + [∗] STATUS key.
(Announces current system status; e.g., “Disarmed Ready to
Arm.”)
To announce faults Press [#] FUNCTION + [0] VOICE + [∗] STATUS + [∗] again.
and Status: (Announces up to three faulted zones with their zone
descriptors, if programmed.)
To Next Page
Loading...
