Firstcom FR-488 - Address List; Factory Default

26
8
General Setting
edition,Press to clear out all letters. 00-127,total 128 group
ID and corresponding ID name.
Press
5.
to conrm and return into main menu.Repeat above
Step 3 and Step 4 operations to edit multi-ID and corresponding ID
name.
Press
6.
key to return into standby status.
Factory Default
If your radio seems to be malfunctioning, resetting the microprocessor
may solve the problem. When performing the reset, you may lose
memory data and stored information. Back up or write down important
data before performing the reset.
Press and hold
1.
key for over 2s to
enter general setting menu.
Press
2.
/ key to choose No.30
menu, LCD displays"RESTORE".
Turn selector knob to select the desired
3.
operation.
FACT:R esu me fac tory d efa ult fo r
channel,signaling and general setting.
SETUP:Return initial setup for No.18-
No 27 general setting menu.
Press
4.
key to conrm.
Press and hold
1.
key for over 2s to enter general setting menu.
Press
2.
/ key to choose No.28 menu, LCD displays"CODE-
OF".
Turn selector knob to enable/disable
3.
Pin setup.
ON: Turn on Pin setup
OFF:Turn off Pin setup
Press
4.
key to confirm and exit.
Default:OFF
Address list
You store desired ID and corresponding ID name in address list.The
LCD displays ID corresponding name if radio received ANI calling and
nd matching ID in address list .
Press and hold
1.
key for over 2s to
enter general setting menu.
Press
2.
/ key to choose No.29
menu, LCD displays “BOOK”.
Press
3.
to enter into ID setting,press
/ t o s e l e c t t h e d e s i r e d
group (00-127,total is 128 group ID).
Turn selector knob to select desired
number,press
conrm and move
cursor to next edition,press to
clear out all digits.
After finishing edition,press
4.
to confirm and enter into
edition of current group's ID corresponding name.Turn selector
knob to select desired letter,press
to move cursor to next