Firstech CM-900 - Option Programming Tables

14
Option Programming Tables
Feature
Default Setting - I
Optional
Setting - II
Optional
Setting - III
Optional
Setting - IV
1-01
Unlock Before, Lock After
Starting
OFF
ON
Lock After Start Only
Lock After Shutdown
Only
1-02
Lock / Unlock Pulse Duration
0.8 sec
2.5 sec
0.125 sec
3.5 sec
1-03
Driver's Priority Unlock
OFF
ON
1-04
Double Pulse Unlock
OFF
Unlock
Lock
Both Lock and Unlock
1-05
Rearm Output
First Lock, After Start
and After Shutdown
First Lock and After
Shutdown
After Start Only
After Shutdown Only
1-07
Unlock/Disarm With Trunk
Release
Unlock, Factory
Disarm, and Trunk
Release
Factory Disarm,
Trunk Release Only
Trunk Release Only
1-09
Ignition Controlled Door Locks*
OFF
ON
RPM Locks (Tach
Sensing Mode Only)
1-11
Ignition / Accessory Out Upon
Unlock
OFF
Ignition Pulse at
same time as Disarm
Accessory at same
time as Disarm
Ignition and
Accessory at same
time as Disarm
1-12
Arm and Disarm Remote
Paging by Datalink Module
ON
OFF
1-13
Double Pulse Disarm
Standard
Double Pulse
1-15
Trunk Output Timing
1 sec
2 sec
3 sec
4 sec
1-16
Horn Mute Control via Remote*
Disabled
Enabled
Feature
Default Setting - I
Optional
Setting - II
Optional
Setting - III
Optional
Setting - IV
2-01
Tach Sensing Type
Optimal Tach
Threshold
Previous Tach
Method
2-03
Diesel Timer
OFF
3-99 sec (12 sec
Default)
7 sec
GM Ignition Delay
2-04
Trigger Start
OFF
Single Pulse
Double Pulse
Triple Pulse
2-05
Cold or Hot Start With FT-
Temp Sensor*
OFF
Cold Start Only
Hot Start Only
Cold and Hot Start
2-06
Timer Start or Minimum Interval
Between Cold Starts
3 Hour (4 Minute
Runtime, Double for
Diesels)
2 Hour Repeat with
Cold Starting of 2-08
(Runtime 2-07)
Reservation (Runtime
2-07)
24 Hour Repeat With
Cold Starting of 2-08
(Runtime 2-07)
2-07
Remote Start Runtime
15 minutes
25 minutes
45 minutes
3 minutes
2-08
Temperature of Cold Starting
-10° C / 14° F
-20° C / -4° F
-5° C / 23° F
-15° C / 5° F
2-09
Temperature of Hot Starting
25° C / 77° F
30° C / 86° F
35° C / 95° F
40° C / 104° F
2-10
Engine Sensing
Tach
Alternator
No Connection (3.0
sec Start-Assume