Firstech CM2500 - Page 10

Alarm
System
www.firstechonline.com | www .compustar.com
CM2500
Install
Guide
Copyright 2022 Fi rstech , LLC. “Are you not entertained…?” Page
10
Universal Security Control Module
Install.myfirstech.com
CM2500
Master
Guide
STEP 4: Once the sensor has been selected hold the programming button for 2 seconds
to confirm selection and enter sensitivity adjustment. The adjustment options
will now be accessible with default setting displayed. (sensitivity options will
be shown in table below.)
STEP 5: push the programming button repeatedly until desired sensitivity level is
reached (setting 0 will indicate sensor is OFF => except option 2 window
break sensor conditions)
STEP 6: Hold programming button for 2 seconds to save sensitivity setting. After the
setting is saved the sensor will start over at sensor 1 again. (if the
programming button is not pressed within 5 seconds after setting the LED
will flash 2 times save the setting and exit that sensor programming)
STEP 7: Turn ignition off to exit programming
STEP 8: You are now ready to test the DAS-II
Adjusting DASII Shock Sensitivity alternative procedure option 1
STEP 1: Turn the ignition to the ‘on’ position.
STEP 2: 2 Way remotes-hold buttons 1 and 2 (Lock and Unlock) for 2.5 seconds. You will get two
parking light flashes. 1 Way remotes-hold Lock and Unlock for 2.5 seconds. You will get two
parking light flashes.
STEP 3: To set the Warn Away Zone 1, (2way LCD) tap lock or button I. (1 Way) tap Lock. After
you get one parking light flash, proceed with impact testing on the vehicle. Note: please be careful as
not to damage the vehicle during the sensitivity adjustments. You will get siren chirps 1-most
sensitive (lightest impact to the vehicle requiring the least amount of force to trigger warn away)
through 10-least sensitive (heaviest impact to the vehicle requiring more force to trigger warn
away). This sets the impact sensitivity of Warn Away Zone 1. Setting Zone 1 will automatically set
Zone 2. If you would like to manually set Zone 2 proceed:
To set Instant Trigger Zone 2
a. Repeat Steps 1 and 2
b. Tap the Unlock button on your Firstech remote, the parking lights will flash 2 times.
c. After you get two parking light flashes, tap the vehicle. You will get siren chirps 1-most
sensitive through 10-least sensitive. This sets the impact sensitivity of Instant Trigger Zone 2.
STEP 4: Once you get two parking light flashes, you are ready to test your DASII.