www.firstechonline.com
|
www
.compustar.com
Copyright 2022 Fi rstech , LLC. “Are you not entertained…?” Page
7
Universal Security Control Module
Install.myfirstech.com
CM2500
Master
Guide
STEP 4: Step on the foot brake (MUST HAVE CN4 PIN 6 connected to foot brake with feature 1-
14 set to option 2) 3 times within 5 seconds *parking lights will flash 1 time to indicate
remote programming is enabled
STEP 5: Tap (a quick 0.5 second press and release) the lock button on the remote * the parking lights
will flash 1 time indicating the remote code has been accepted
STEP 7: After 10 seconds of no valid remote codes being transmitted the CM will automatically exit
programming mode Note: If no valid remotes are programmed the CM will enter valet
mode.
Placement and Use of Components
IMPORTANT:
The placement and use of components are critical to the performance of this
system.
Antenna and Cable
If you are adding one to this system, please note Firstech antennas are calibrated for horizontal
installation at the top of the windshield. The cable
that connects
the antenna to the control module
must be free from any pinches or kinks. Installing the antenna in areas other than the windshield
may adversely affect the
effective
transmitting distance of the
remotes.
FT-Shock II
This is an analog dual stage impact + a fixed 2.5 degree tilt sensor included with the CM900AS kit. The
CM2500A is default to accept the FT-shock II and provides warn away and full trigger outputs for both
Shock and Tilt. There is a dial located at the end of the FT-shock II with settings from “off” then 1-10
sensitivity level, 1 being the least sensitive and 10 being the most sensitive (10 will pick up the wind
blowing ѮѯѰѱ). We recommend mounting the sensor with the plastic mounting strap included preferably as
centered to the vehicle as possible. Due to its extreme sensitivity the vehicle plastic heater ducting makes for
a good mounting surface. The Tilt portion is auto calibrating so once its mounted, then armed it will look for
a 2.5 degree tilt from that location.
LED (external)
There will be an external mountable Blue LED for theft deterrent included. It is important to discuss
mounting locations with the end user, trying to make it visible and bright when recommending
locations. The LED will light up solid blue when armed for approx. 25 seconds allowing the impact
sensor to set up. Once the LED is flashing the sensors are ready. The LED will also provide security
diagnostics:
To Next Page
Loading...