Firstech CM2500 - Valet Mode

Alarm
System
www.firstechonline.com | www .compustar.com
CM2500
Install
Guide
Copyright 2022 Fi rstech , LLC. “Are you not entertained…?” Page
14
Universal Security Control Module
Install.myfirstech.com
CM2500
Master
Guide
Valet Mode
Valet Mode disables all system features except for the keyless entry. Use Valet when servicing or loaning
your vehicle to others to avoid any inconvenience or mishap when operating the vehicle. There are no visual
indicators when the security system is in Valet Mode. There is a parking light diagnostic flash when remote
starting in Valet Mode. (3 flashes followed by 10 flashes). Also, when in Valet Mode, the keyless entry
feature will still operate.
The system can be put INTO valet mode one of 5 ways:
**NOTE: CM2500 does have a FOOT BRAKE input using the (+) door input (red/black wire pin 6)
changing feature 1-14 to option 2
1. While holding the foot brake (12V+ brake input), cycle the key to the Ignition or ‘On’ position and
then back to the ‘Off’ position 5 times within 10 seconds. The parking lights will flash once indicating
that the system has entered Valet Mode.
2. Turn the key to the Ignition or ‘On’ position then using a 4-button remote press and release the lock and
trunk buttons together simultaneously for a half second. The vehicle parking lights will flash 1 time to
indicate the system has successfully entered valet mode. When using 3 or 5-button remote there will be
remote specific steps to enter valet, please see remote user’s manual for further instructions.
3. The user may enter valet mode by performing the PTS vehicle remote programming procedure and
make sure there are no remotes transmitting.
4. Drone Mobile app will allow a user to enable/disable VALET mode within the vehicle settings section.
1. Open the Drone Mobile app
2. Open settings
3. Open “Vehicles”
4. Select Vehicle
5. Open “System”
6. Toggle Valet on or off
7. Tap “Save” top right corner of the app.
**NEW
5. (-) Wired Valet mode input that can be connected to a latching or momentary toggle switch (NOT
INCLUDED). ENTER and EXIT valet mode will use the same procedure. NOTE: When the system has
been set to wired valet mode input, procedure 1 WILL NO LONGER FUNCTION!
1. Hold the (-) Valet input to ground for minimum of 5 seconds
2. After 5 seconds to ground, tap the (-) Valet Input to ground 5 times
3. The park lights will flash
-1 time for enter Valet mode
-2 times for exit Valet mode