2. Go to the Ignition or ‘On’ position, then to the “off” position, then back “on”. Press and release the foot
brake of the vehicle 3 times. After a short period of time the vehicle parking lights should flash 1 time
indicating it has entered “valet mode”. Repeat this process to exit valet mode, and the parking lights will
flash twice.
3. Turn the vehicle’s key to the ignition “on” position, enter the user function settings (quick double tap
the center button). Then, using the unlock button (or right arrow button) move through the features until
the “Valet off” option is displayed. Tap the center button one time for ½ second to activate valet mode.
The parking lights will flash once, the remote will read “Valet On”. Repeat this process to exit valet mode.
The parking lights will flash twice, remote read “Valet Off”
Proximity Unlocking feature
Both remotes included will offer the proximity unlocking feature, it is default to the on position, but it can
be disabled anytime from either remote. Note: Activating the proximity function with 1 remote will
activate the function for all the proximity compatible remotes that are programmed.
2WT13 – Proximity Enable/Disable
To enable/disable the proximity feature from the remote enter the user feature settings (quick double tap
of the center button) tap the “LOCK” or left arrow button until you see the “Proximity On” feature. Tap the
center button quick to toggle the feature on or off. The vehicle should respond with 1 parking light flash
for “ON” and 2 parking light flash for “OFF” to confirm the action. If there is no response, or the feature
does not allow the feature to be changed you may need to have your install tech set the proximity feature
on the main control module installed in the vehicle.
2WR5 – Proximity Enable/Disable
Enter the user feature settings: 1 quick tap then HOLD the button for 5 seconds. The remote will indicate
it is in the user feature mode:
-to enable proximity tap the button 1 time, the Unlock LED will flash BLUE
-disable the proximity unlock tap the button 1 time, the LOCK LED will flash RED
Alarm alerts/Notifications
The 2WT13 and 2WR5 remotes support “Alarm full mode”. This allows the remote to be used with any of
our systems that support security features, remote start features or both security and remote start
features! Remotes in “Full alarm mode” will receive alarm alerts/notifications (when within range of the
vehicle) if the alarm system is triggered. NOTE: your Firstech security system is equipped with a “soft
disarm” feature which means 1 unlock/disarm command will only silence or shut off the siren once it
To Next Page
Loading...
Need help?
General
