Fisher & Paykel ACTIVESMART RS32A72 - Custom Door Panel Installation Dimensions - Rs32 A72

10
7 CUSTOM DOOR PANEL INSTALLATION DIMENSIONS — RS32A72
Dimensions apply for the preparation and installation of custom door panels. For Dwg and Dxf files of the below panel preparation download the folder on http://thekitchentools.fisherpaykel.
com/downloads/.
Ensure handle is mounted
65mm from inner edge of panel
to the center — this will avoid
interference with brackets.
1 3/8" (34.7mm)
1 3/8" (34.7mm)
4 5/16" (364mm)
2 3/16" (54.8mm)
40" (1016mm)
Ø 2mm REF
12x Pilot holes recommended for bracket attachment.
(Do not penetrate front surface).
13 1/2" (342.3mm)
TOP PANEL — REAR VIEW
All measurements to be made
from inner bottom corner.
Forthe second panel mirror
and repeat dimensions using
inner bottom corner as the
reference point.
Ø 2mm REF
10x Pilot holes recommended
forbracket attachment.
(Do not penetrate front surface).
13 3/16" (335mm)
4 3/8" (111.5mm)
1 1/8" (29.1mm)
3 7/16" (87.2mm)
19 3/8" (492mm)
21 5/16" (542mm)
14 7/16" (366mm)
All measurements to be made
from top and centerline.
BOTTOM PANEL — REAR VIEW
Cut outs are located in attachment bracket for Fisher & Paykel handles only.
Iflocating custom handle in the shaded area above, ensure handle screw heads
are counter sunk into back of panel to avoid interference with hanging bracket.
415/16" (126.1mm) 615/16" (176.1mm)
2415/16" (633.6mm)
2615/16" (683.6mm)
385/8" (981mm)