24
!7 POSITIONING INTO CABINETRY
Position the appliance into the cabinetry
1
Ensure the power cord are secured to the clip at the back
of the appliance (A) and the excess water hose coiled flat
behind the appliance.
2
Push the appliance into the cabinetry until the anti-tip bracket
overlaps the rear top edge of the appliance (B).
– Ensure the appliance is centered.
– Ensure there is firm contact between the appliance and
anti-tip bracket withamin.2 3/8" (60mm) overlap (C).
B
A
IMPORTANT!
● ●
Your appliance is fitted with front and rear rollers designed for moving the appliance in
the forwards and backwards direction.
● ●
Avoid moving the appliance in a sideways direction as this may damage the rollers or
the floor covering/surface.
●
● ●
Ensure the hose is not run over by the appliance when pushing into the cabinetry to
prevent damage and possible water leaks.
● ●
Ensure water tubing is routed away from any sharp objects, sharp corners (beware of
kinking the tube as this will stop water flow), and not in a location where it can be kinked
or squashed.
Refer to 'Attach anti-tip bracket' (page19) for more information.
Min. 2 3/8"
(60mm) overlap
Anti-tip
bracket
To Next Page
Loading...
