Fisher & Paykel ACTIVESMART RS32A72 - Cavity Preparation

19
!2 CAVITY PREPARATION
Internal box
A
Anti tip
bracket kit
Anti-tip bracket
(1)
Masonry plug
(4)
#10x40 Pan Head Philips Screw
#10x40 Pan Head Philips Screw
#10x40 cross-head screw
(4)
Tools
Cross-head screwdriver
Powered driver (optional)
Pencil
IMPORTANT!
●
The anti-tip bracket and fittings supplied must be fitted to the wall
ofthefinished enclosure to withstand 220lbs (100kg) load.
●
Ensure that anti-tip bracket is installed correctly to prevent the
appliancetipping forward when door is open.
●
Ensure the bracket is secured to structural beams or wall studs
nearesttothe center of the alcove.
WARNING!
Read the following before fastening with masonry plugs and / or screws:
●
Ensure the screws avoid electrical, gas and water conduits.
●
Ensure lightweight masonry material such as cinder block
andnewconcrete (no curing time) are not used in installation.
●
Do not use metallic materials that may corrode, stain and / or
damagetheenclosure.
Attach anti-tip bracket
If the minimum 60mm
overlap cannot be
achieved, install a solid
spacer to the wall stud
behind the bracket.
IMPORTANT!
When positioning the appliance
in the cabinetry, ensure that the
anti-tip bracket overlaps the
appliance by a minimum 2 3/8"
(60mm) for a secure hold.
.
2 3/8" (60mm)
overlap
.
2 3/8" (60mm)
overlap
Anti-tip
bracket
Spacer
Anti-tip
bracket
D
E
B
C
1
Project horizontally from the bottom edge of the finished enclosure towards
the center of the back wall (A). This will locate the contact surface between
the bracket and appliance.
2
Mark the location for placement of the anti-tip bracket. Place the bracket so
the top edge of the contact surface aligns with the mark (B).
3
Mark the locations of the screw holes on the wall based on the most central
wall stud (C).
4
Drill screw holes to the marked locations.
5
For wooden/plaster board wall installation:
– Fix the bracket to the wall with 10x40 pan head cross-head screws, and
screw tightly (D).
6
For solid wall installation:
– Hammer masonry plugs into the wall until flush.
– Fix the bracket to the wall with 10x40 pan head cross-head screws
(4x), and screw tightly (E).
Anti-tip
bracket
A