28
B
D
C
A
E
Tools
Cross-head screwdriver
Powered driver (optional)
Hex key
FPA spanner
!9 DOOR PANEL INSTALLATION — STAINLESS STEEL
Attach the door panels
1
Open the door and loosen the M5x10 cross-head
screws (do not remove) at the sides of the doors (A).
2
Hang the door panel by inserting the M8 studs
through the holes of the hanging bracket (B).
3
Slide the forks of the side brackets onto the
screws of the door (C).
4
Screw the M8 washer and nut to each stud
(D), and re-tighten the side screws (E) using
the hex key and spanner to fix the door
panel (do not fully tighten). This will allow
opening the door without affecting
adjustment of the door panel.
To Next Page
Loading...
