Fisher & Paykel ACTIVESMART RS9120W - HANG NON-WATER DISPENSING DOOR PANELS; Panel Alignment and Adjustment

24
5
Lock top inner panel side screws
to allow opening the doors
without affecting adjustment.
(Open the left door to lock the
right screws and vice versa (C).)
6
All door panels have
full axis adjustment to
ensure they are flush with
adjacent walls. To adjust
the height of each panel
turn clockwise to raise
stud or counter-clockwise
to lower stud (D).
7
Once satisfied with all
door panels, secure
M8 studs with M8 washer
and M8 nut (E). The top
of the stud must remain
below the top face of the
door panel.
8
Secure side bracket forks
by tightening side screws (F).
Repeat this process for all door panels.
Note:

For depth adjustment loosen side screws (4x),
adjustpanels and then retighten oncesatisfied.

Further adjustment of door panels can be achieved
byremoving door panels then loosening the fixing
screws for the hanging bracket and moving the
bracket sideways to suit.
9
Loosely install locking bracket (G) into the pocket on the underside of the door using
aM8 stud. Slide the locking bracket out until it touches the back of the door panel.
Screw in place using a #8x16 screw through one of the three slotted holes.
Fullytighten the M8 stud.
Place a ruler on the front of the
product to check flushness top
and bottom, left and right.
IMPORTANT!
Remove protective film from white product
doors before hanging door panels.
1
Hang all door panels onto M8 studs and align
the side bracket forks onto the refrigerator
door (A).
– Ensure the forks are positioned around
the body of the side screws (M5x10 pan
head Phillips screw).
2
Push the product until the door panels
areflush.
– Depending on your installation design
this will be flush with your adjacent
cabinetry or your framework.
3
Place a ruler on the front of the product to
check flushness top and bottom, leftand
right (B).
4
Ensure the gap between the top of the door
panel and the top cabinetry is no greater
than 7mm.
– To reduce this gap, raise the product
by turning all four adjustment nuts the
same number of turns.
IMPORTANT!
Failure to follow these steps can lead to
difficulties in door panel adjustment and
cosmetic cap fitment.
For Fisher & Paykel Stainless steel door panels only.
E
D
F
G
A
B
C
!9 HANG NON-WATER DISPENSING DOOR PANELS