Fisher & Paykel ACTIVESMART RS9120W - ATTACH SIDE TRIM BRACKETS - [A] FLEXIBLE SPRING CLIP METHOD

2929
A
PlasticAluminium
3
Position 3 side trim brackets onto each side trim.
Note: measure from the top of the trim, with
the shorter lip at the bottom. (Referto (B) for
2032mm and 2134mm bracket locations and trim
orientation).
IMPORTANT!
Each bracket has two engagement points
for the side trim to locate. Ensure the trim is
engaged in both points (C).
Repeat this process for the remaining side trim.
2032mm = 229mm
2134mm = 330mm
2032mm = 914mm
2134mm = 1016mm
2032mm = 1651mm
2134mm = 1753mm
0
B
Discard
Top view of side trim engaged
correctly in side trim bracket
C
Side trim
bracket
Side trim
IMPORTANT!
Before installing your refrigerator, ensure the dimensions of the finished enclosure are correct for your refrigerator following the‘Product and cavity dimensions’ sections.
@4 ATTACH SIDE TRIM BRACKETS – [A] FLEXIBLE SPRING CLIP METHOD
1
Break off the datum lip to each side
trim bracket and discard.
Repeat for all side trim brackets.
For 2032mm cavity installation only
2
Measure 102mm from the top, shorter
side trim and carefully cut using a fine
tooth hacksaw to a length of 1930mm.
Referto (A) for orientation of side trim.
Note: Ensure cut is straight and square
as this is an exposed surface. Also ensure
the plastic part does not bend as this can
causevisual stress marks.
Repeat this process for the remaining
sidetrim.
TWO METHODS ARE AVAILABLE FOR ATTACHING SIDE TRIM BRACKETS:
[A] FLEXIBLE SPRING CLIP METHOD – RECOMMENDED METHOD
[B] FIXED SCREW METHOD – METHOD TO USE IF CABINET IS NOT TO SPECIFICATION
(Attempt method [A]. If method [A] results in poor fitment of side trims due to cabinetry that is uneven or out of specification, use method [B]).