Fisher & Paykel ACTIVESMART RS9120W - ATTACH SIDE TRIM BRACKETS - [B] FIXED SCREW METHOD

31
3
Position three side trim brackets on each side (refer to (B) for bracket locations).
Opentherefrigerator door. Measure 50mm from the front of refrigerator
(frombehindthe door), to the front of the alcove and accurately mark a vertical
line (C).
Align the bracket edge with the marked line and using screws x2 (#8x16 mush
washer) fix the bracket to the cabinetry x3.
Repeat on the opposite side.
IMPORTANT!
Inaccurate positioning of bracket can result in inability to fit side trim or gaps
between side trim and refrigerator.
A
PlasticAluminum
For 2032mm cavity installation only
2
Measure 102mm from the top, shorter side
trim and carefully cut using a fine tooth
hacksaw to a length of 1930mm. Referto
(A) for orientation of side trim.
Note: ensure cut is straight and square
as this is an exposed surface. Also ensure
the plastic part does not bend as this can
causevisual stress marks.
Repeat this process for the remaining
sidetrim.
0
B
254mm
1016mm
1753mm
50mm
Front of
cabinet
If method [A] Flexible spring clip method, has resulted in poor fitment of side trims due to cabinet being
out of spec, use method [B] Fixed screw method.
IMPORTANT!
Before installing your refrigerator, ensure the dimensions of the finished enclosure are
correct for your refrigerator following the‘Product and cavity dimensions’ sections.
1
Break off the datum lip to each side
trim bracket and discard.
Repeat for all side trim brackets.
Discard
50mm
C
@5 ATTACH SIDE TRIM BRACKETS – [B] FIXED SCREW METHOD