Need help?Do you have a question about the Fisher & Paykel DD603(I) and is the answer not in the manual?
General| Type | Built-in |
|---|---|
| Energy Rating | 3.5 Stars |
| Noise Level | 44 dBA |
| Wash Programs | 6 |
| Height | 820 mm |
| Width | 598 mm |
| Control Type | Electronic |
| Delay Start | Yes |
| Child Lock | Yes |
| Color | Stainless Steel |
Details compartments and usage for pre-wash and main wash detergent.
Explains the function, adjustment, and filling of the rinse aid dispenser.
Accelerates drying and increases shine by reducing water surface tension.
Guidance on adjusting rinse aid levels for water hardness and results.
Warns about irreversible etching on glassware from excessive detergent.
Details issues like spotting, reduced performance, and scale build-up.
Advises using a water softener for hardness over 200ppm/200mg/l.
Details test procedures and requirements for energy labelling in AU/NZ.
Compares energy consumption, water usage, and stars across regions.
Provides instructions for cleaning the drawer, filter, spray arm, and plate.
Guides on cleaning the motor assembly, rotor locking ring, and heater plate.
Explains how fault codes are displayed for prefinished and integrated models.
Steps to clear codes and when to contact service.
Diagnostic steps for motor issues.
Diagnostic steps for temperature sensor or element faults.
Diagnostic steps for heating element or sensor faults.
Diagnostic steps for EEPROM access errors.
Diagnostic steps for water inlet and priming issues.
To Next Page
